Pump Flow Valve
An economical alternative to the standard Demand flow regulator. This is to be used with instruments having built in Vacuum pump.
SPECIFICATIONS
Inlet Pressure:
70 bar
Outlet Flow:
0 to 3 L/Mn
Inlet Connection:
C10-5/8” x 18 UNF-M
Outlet Connection:
Barbed Outlet
Material:
Brass
Warranty:
1 year
Related products
C10 DA Valve
Duo Fixed Flow Regulator
The Duo flow regulator is designed to have a button on top for temporary release of gas if the button is pressed down to prevent accidental loss of gas and a rotating cap for situations where continuous flow of gas is required and the regulator is needed to be in on position.
Both mechanisms are easy to use for outlet flow rates of 0.5 L/Mn and 1.0 L/Mn
SPECIFICATIONS
Inlet Pressure:
70 bar
Outlet Flow:
0.5 L/Mn & 1.0 L/Mn
Inlet Connection:
C10-5/8” x 18 UNF-M
Outlet Connection:
Barbed connection & Taper Shank adaptable to Polyurethane tube.
Material:
Brass
Warranty:
1 year
CGA 165 Valve
Multi Flow Regulator
Multi Flow regulator is a single stage piston style regulator. The regulator has 9 selectable flow settings. Used with corrosive and non-corrosive gases.
SPECIFICATIONS
Inlet Pressure:
70 bar or 200 bar
Outlet Flow:
0 to 3 L/Mn, 0 to 5 L/Mn, 0 to 8 L/Mn, 0 to 15 L/Mn
Inlet Connection:
C10-5/8” x 18 UNF-M or 1/4“ NPT F for the high Pressure
Outlet Connection:
Barbed or Compression fitting
Material:
Brass or Stainless Steel
Warranty:
1 year
Rupture Disk C10 Valve
This type of valve acts like a standard C10 valve and comes with a disk which ruptures when the pressure doubles during filling of cylinder.
The rupture disk acts as prevention for accidental over-filling of gas into the cylinders.
SPECIFICATIONS
Inlet Pressure:
90 bar
Inlet Connection:
1/14” UNS
Outlet Connection:
5/18” UNF-F
Material:
Stainless Steel
Warranty:
1 year
Fixed Flow Regulator
Fixed Flow Regulator is manufactured to give various fixed flow rates and is compatible with all gas cylinders with a C10 connection.
It is one of the most common regulators used in the world of gas Calibration and comes with a wide range of flows that are set as per your need.
Suitable for Oxygen as all parts are made of Brass and range from 0.5 L/Mn to 25 L/Mn.
SPECIFICATIONS
Inlet Pressure:
70 bar
Outlet Flow:
0.5 L/Mn to 25.0 L/Mn
Inlet Connection:
C10 ( 5/8″ x 18 UNF -M )
Outlet Connection:
Barbed connection
Material:
Brass / Stainless Steel
Warranty:
1 year
Push Button Fixed Flow Regulator
Push Button Regulator comes with a ON/OFF button on its top as preventive measure for accidental loss of gas and is mainly used for Bump Testing.
SPECIFICATIONS
Inlet Pressure:
70 bar
Outlet Flow:
0.5 L/Mn & 1.0 L/Mn
Inlet Connection:
C10-5/8” x 18 UNF-M
Outlet Connection:
Taper Shank Adaptable to Polyurethane Tube
Material:
Brass & Stainless Steel
Warranty:
1 year